Backup the original firmware. You'll need to replace VARIABLE with your micro-controller version: atmega8, atmega48 or atmega88Īvrdude -c usbasp -p VARIABLE -U flash:r:flash-usbasp. ![]() Copy the correct firmware to the avrdude directory. Finally connect the programmer to the computer USB port.Set both USBasp to 5V on jumper J1 and connect them via a 10 pin cable.To update the firmware you also need to set jumper J2 on the USBasp to update as explained in the Readme.txt. ![]() avrdude: AVR device initialized and ready to accept instructions Reading 100 0.00s avrdude: Device signature 0x1e910a avrdude: NOTE: FLASH memory has been specified, an.
0 Comments
Leave a Reply. |